Inside Wood-Burning Stove
From: 510 €
Description of a Basic Set:
- Chimney lower part 32 cm, Ø114 mm, welded to the combustion chamber
- Chimney 1 m, Ø114 mm
- Chimney 1 m, Ø 114 mm, with Rain cap
- Ashpit
- Assembly materials are included
Maximum length of firewood: 480 mm
- Parameters
- Description
The stove is designed to heat water in hot tubs with a volume of 500 to 3000 liters.
The fuel for the stoves can be firewood of various tree species such as birch, spruce, pine, etc.
Stoves basic conditions for use:
– The stoves are specially designed for the Baltresto Production OÜ wooden and fiberglass hot tubs. Operation with other hot tubs and hot tub liners is not guaranteed.
– Maximum acceptable water temperature in the hot tub is 45 degrees.
– It is not allowed to close the input and output pipes of the stove during the burning and until the stove is cooled down. (for the external stove)
– It is not allowed to create extra pressure in the stove. (for the external stove)
– It is not allowed to let the water freeze in the stove. (for the external stove)
– It is not allowed to let the water freeze in the hot tub. (for the internal stove)
– It is not allowed to use the stove without water inside the hot tub.
Aluminium 27 kW
- Height – 80 cm
- Length – 65 cm
- Width – 35 cm
- Weight – 20 kg
- Capacity – 27 kW
Stainless Steel 24 kW
- Height – 80 cm
- Length – 65 cm
- Width – 35 cm
- Weight – 28 kg
- Capacity – 24 kW
Description
Ensure good operation and long life of the device by following water quality limit values below.
- Chlorine content: max 3.5 mg/l (ppm)*
- pH value: 7.2–7.6
- Alkalinity: 60–120 mg/l (ppm)
- Calcium hardness: 100–300 mg/l (ppm)
- Iron: max 0,1 mg/l (ppm)*
- Copper: max 0,2 mg/l (ppm)*
- Manganese: max 0,05 mg/l (ppm)*
- Phosphorus: max 0,01 mg/l (ppm)*
- Nitrate: max 50 mg/l (ppm)*
- Chloride (salt) content: max 250 mg/l (ppm)
- Chloride (salt) content: max 35 000 mg/l (ppm) – titanium for salt water
While choosing a stove for a hot tub, it is necessary to remember that it has to be service-strong, high-quality and economically sound. Right choice of a stove for a tub is a basis for your further convenient bathing. Thus, one should take an issue of choosing an ideal stove for a hot tub seriously enough. For example, inside stove is a rather economical choice. Such a stove is located in a special compartment inside the hot tub. Stove is usually filled with the firewood from the top. The water gets warm quickly enough due to the contact with the wall of a stove. Thus, the water heats both quickly and evenly. Baltresto inside stoves are made of high-quality marine aluminum, or stainless steel. It is very important to drain water out of the heater during the winter time, if the hot tub is not used. In case this rule is not observed, water may freeze and damage the stove.
